Barber Motorsports Park And Splitters
#1
Drifting
Thread Starter
Barber Motorsports Park And Splitters
Does anyone know if a front splitter about 3 1/2 inches off the ground will clear the curbing at 7A, I have always jumped over this curb but I have not been back there since I added the aero. I also drive over the curbing at 13, but it seems very low and smooth.
Thanks in advance...
Thanks in advance...
#2
Le Mans Master
I don't remember either one of those areas to be very high or bumpy.
You'll have a lot of compression in 13, but the curbing there is very short - wide, but short.
You'll have a lot of compression in 13, but the curbing there is very short - wide, but short.
Last edited by sperkins; 08-19-2012 at 06:28 PM.
#3
Le Mans Master
I am going to find out October 6, 2012!
Jim
Jim
#4
Drifting
Thread Starter
Thanks, I really think I will be ok, I am going to leave it at 3 1/2 inches for now. Unless I hear otherwise..
#7
Drifting
Thread Starter
#8
Le Mans Master
Dennis, here's a picture I found of 7A.
This looks like it might be 13:
This looks like it might be 13:
#9
Drifting
Thread Starter
Thanks Jody, 7A looks pretty flat in that picture, I have been over it several times pre aero and it never seemed like it was very high.
I don't think that is 13, it looks more like 12? but I am not for sure?
Thank you for finding those
I don't think that is 13, it looks more like 12? but I am not for sure?
Thank you for finding those