stonabones aka; Kyle
#1
Intermediate
Thread Starter
Member Since: Nov 2011
Location: Colorado
Posts: 32
Likes: 0
Received 0 Likes
on
0 Posts
stonabones aka; Kyle
Anyone know or familiar with what the exhaust setup was on Kyles car?
Header size, mufflers and just overall exhaust configuration?
Here are a couple vids of it and its very nice tone. And I'm not sure which of his motors were in the car in the videos below but these are the ones I'm curious about.
I dont see him on here much anymore and hoped some of you might know.
Header size, mufflers and just overall exhaust configuration?
Here are a couple vids of it and its very nice tone. And I'm not sure which of his motors were in the car in the videos below but these are the ones I'm curious about.
I dont see him on here much anymore and hoped some of you might know.
#3
Intermediate
Thread Starter
Member Since: Nov 2011
Location: Colorado
Posts: 32
Likes: 0
Received 0 Likes
on
0 Posts
Haha, yeah sounds like a mild RV cam to me or maybe some sort of 3/4 race cam. Either way I'm pretty sure its just bolt-ons!
Seriously though, anyone care to share some info?
Burn stainless muffler?
Mark, Kyle, you guys around?
Seriously though, anyone care to share some info?
Burn stainless muffler?
Mark, Kyle, you guys around?
#5
Drifting
Member Since: Apr 2008
Location: TIRECRAFT RACING NJ
Posts: 1,607
Likes: 0
Received 0 Likes
on
0 Posts
2 inch American Racing headers , 3 inch x pipe to 6 inch oval spin tech muffler to 6 inch oval tail pipe turned down at end of tunnel
Also 850 HP of 13:1 compression and 750 lift adds to the noise
Also 850 HP of 13:1 compression and 750 lift adds to the noise