Any Tips for Transgo shift installation for a Th-400
#1
Team Owner
Thread Starter
Any Tips for Transgo shift installation for a Th-400
Looking for Maximum performance out of the shift transformer ...I have about 370hp and a 2400 stall.Any recommendations on hole sizes to drill for maximum tire chirping performance.............Thanks for the tips guys
#2
Re: Any Tips for Transgo shift installation for a Th-400 (Alwyn678)
I've got the kit set on the #2 size holes... (I'm at work so I don't have the manual here).
It chirps slightly between 1-2 at WOT.
At low throttle there is a HARD 1-2 shift, that is felt more than heard.
I'd say start at the #2 setting, and open her up more if its not enough for you.
It may get on yer nerves to have it chirping ALL the time.
And, as you know, you can't make the holes smaller once you drill them out.
It might involve some extra work to get where you want it... unless you go for broke and set it to #4 and just say the hell with it. (I kept it at #2 'cause of my woman's nervousness in the car)
It chirps slightly between 1-2 at WOT.
At low throttle there is a HARD 1-2 shift, that is felt more than heard.
I'd say start at the #2 setting, and open her up more if its not enough for you.
It may get on yer nerves to have it chirping ALL the time.
And, as you know, you can't make the holes smaller once you drill them out.
It might involve some extra work to get where you want it... unless you go for broke and set it to #4 and just say the hell with it. (I kept it at #2 'cause of my woman's nervousness in the car)