FT or FS: used Kooks Headers 1 7/8 w/ xpipe for 1 3/4 $800
 

Sold

I have a SLP setup with 1 3/4 longtubes with high flow cats. I have recently swapped a ls7 and these are probably too small. I made 470 RWHP with these on a mustang dyno and TI exhaust. They have less than 4K miles on them and are in near perfect shape with even a 02 bung welded for wideband.

Sorry, I'm planning to do the install myself and I've read the SLPs are good, but on the tougher side to install. Thanks though.

Sent pm

PMs replied, still looking

Dynatech Supermaxxx?

Yes, definitely interested in the Dynatechs if they have catted x-pipe and fit 01-04. Let me know.

PMd..

just to let you know, few members here did upgrade to 1 7/8 and did not lost any troque and HP numbers even at low rpm range. so keep it. GL on whatever you decide.

Posted pics

Thanks, if I don't find something or sell them in a couple weeks, I'll be happy to keep them.

Updated price...$1000 shipped within US lower 48.

Ttt

I have LG Pro 1 3/4 headers, ceramic coated, AIR pipes deleted with off-road x-pipe that i was planning on selling and purchasing a set of 1 7/8 headers... this might be a good alternative for both of us?

Thank you for all the interest! PMs answered.

Still available for sale and trade. Really looking for a full emissions setup, but will still consider trade if the x-pipe is catless, but the AIR tubes are there.

Shipping is expensive due to the one piece x-pipe, so trades are tough unless you're close to NJ or have a full emissions friendly setup.

Lowered price...$800 picked up or $900 shipped in CONT US

Ttt

Ttt

Last chance, keeping them if not sold by tomorrow night.

After way too much thinking, I decided to buy a set of XS Power 1 3/4 cus I really wanted cats. These are now for sale...good deal...$900 shipped or $800 picked up.