SFV or Simi Valley Shop for Remote Cutout Install
#1
Melting Slicks
Thread Starter
Member Since: Feb 2006
Location: Simi Valley California
Posts: 2,544
Received 123 Likes
on
81 Posts
St. Jude Donor '06-'07-'10, '15. '22-'23
SFV or Simi Valley Shop for Remote Cutout Install
Anyone know of a trusted shop in the San Fernando Valley or Simi Valley area that has done remote cutout installation on a C7? Thanks!
The following users liked this post:
C6 MoneyPit (04-06-2016)
The following users liked this post:
C6 MoneyPit (04-06-2016)
#5
Melting Slicks
Thread Starter
Member Since: Feb 2006
Location: Simi Valley California
Posts: 2,544
Received 123 Likes
on
81 Posts
St. Jude Donor '06-'07-'10, '15. '22-'23
Hey Keith! Hope all is well with you and we get together again one of these days! I'm still trying to figure out how to keep the NPP if possible and make it sound more aggressive - if this doesn't work out I guess I'll have to go to plan "b"".... I should have skipped the NPP and gone aftermarket from the start.
The following users liked this post:
REKCUF (04-06-2016)
#8
Melting Slicks
Thread Starter
Member Since: Feb 2006
Location: Simi Valley California
Posts: 2,544
Received 123 Likes
on
81 Posts
St. Jude Donor '06-'07-'10, '15. '22-'23
Well Keith, sadly it's not going to happen. After getting the car up on the lift and looking at the kit, there is no realistic way to fit this in there in the C7, at least with the auto. Perhaps if one were willing to cut part of the skid plate and do some serious fabrication but it's not worth it. So it's either live with the NPP or go to plan B...cat back with X pipe if I want to bite that bullet...
#9
Safety Car
Well Keith, sadly it's not going to happen. After getting the car up on the lift and looking at the kit, there is no realistic way to fit this in there in the C7, at least with the auto. Perhaps if one were willing to cut part of the skid plate and do some serious fabrication but it's not worth it. So it's either live with the NPP or go to plan B...cat back with X pipe if I want to bite that bullet...
#10
Safety Car
Well Keith, sadly it's not going to happen. After getting the car up on the lift and looking at the kit, there is no realistic way to fit this in there in the C7, at least with the auto. Perhaps if one were willing to cut part of the skid plate and do some serious fabrication but it's not worth it. So it's either live with the NPP or go to plan B...cat back with X pipe if I want to bite that bullet...