CPR built Z making some noise!
#1
Supporting Vendor
Thread Starter
CPR built Z making some noise!
We just finished up Jason's C7 Z that he brought to us from El Paso, TX. The car came to us with an AFE intake and a tune from another shop that left a lot to be desired in terms of drivability.
Baseline dyno video: 569 rwhp 578 rwtq.
We then added one of our custom grind cam's (mid 220 intake duration) longtube headers, alky control meth kit, heat exchanger upgrade, 2.14 pulley
Driving/idle video:
Dyno:
670 rwhp 654 rwtq
This w/ our 91 octane gas and meth, along w/ crazy 104 degree outside air temps! The car drives 100% like a stock vehicle and since it has a smaller cam you get awesome low/mid range grunt that bigger cam's lose. We really don't favor big cam's on any pd blower car to be honest.
Baseline dyno video: 569 rwhp 578 rwtq.
We then added one of our custom grind cam's (mid 220 intake duration) longtube headers, alky control meth kit, heat exchanger upgrade, 2.14 pulley
Driving/idle video:
Dyno:
670 rwhp 654 rwtq
This w/ our 91 octane gas and meth, along w/ crazy 104 degree outside air temps! The car drives 100% like a stock vehicle and since it has a smaller cam you get awesome low/mid range grunt that bigger cam's lose. We really don't favor big cam's on any pd blower car to be honest.
__________________
Cordes Performance Racing aka "CPR"
Owner of AZ's premier LSX/LTX motorsports shop
http://cordesperformanceracing.com/
www.facebook.com/cordesperformanceracing.com
joe@cordesperformanceracing.com
480-359-5914
Cordes Performance Racing aka "CPR"
Owner of AZ's premier LSX/LTX motorsports shop
http://cordesperformanceracing.com/
www.facebook.com/cordesperformanceracing.com
joe@cordesperformanceracing.com
480-359-5914