A forum member emailed me for tips on installing these screens. I copied and pasted my reply here for all to see. Hope this helps. First of all, you need to remove the black plastic housing from each of the headlights…turn on the headlights, then switch them off so that just your parking lights are […]

Someone posted this a while back in C4 tech. Corvette VATS Key Codes and Associated resistance Codes in OHMS Pellet Resistance Code Ohms 1 – 402 2 – 523 3 – 681 4 – 887 5 – 1130 6 – 1470 7 – 1870 8 – 2370 9 – 3010 10 – 3740 11 – […]

Valentine One Install By Cy Stanton (Dittohead) The following procedure is for �hard wiring� the Valentine One (V1) Radar Detector in the C5 (all models), thus eliminating the ugly cord hanging down from your V1 to the cig lighter. We will start by wiring the �direct wire power adaptor� that came with your V1, to […]

Introduction. I basically followed this post http://www.c5-corvette.com/c5_alarm.htm The only thing I did different was placing the shock sensor against the drive tunnel – still effective but much easier that way. Materials. You�ll need a shock sensor. I�ve used a CodeAlram IR-S shock sensor, which I got from a local CodeAlarm dealer for $30. The sensor […]

Background The \’85-\’89 L98 uses an Electronic Spark Control (ECS) module to listen to the Knock Sensor and report ping to the ECM (on \’90-\’96 Corvette motors the ECM listenes directly to the Knock Sensor). When the ECM detects knock counts it pulls timing till no knock is reported and then gradually increases timing to […]