This page describes the replacement of the passenger side “breadbox” on a 1987 Corvette Coupe. The breadbox is being replaced with a kit from Mid-America Designs. There are several other kits that I have seen. One has a map pocket in the front. Another has what looks like the breadbox but has a small glovebox […]

I ordered my seals form Eckler´┐Żs. Fit was perfect and included six replacement pop rivets but no instructions. I use a combination of previous posts and a little common sense to get the job done. The procedure was done on my 91. Adjustments should be made for other years. Took about 30 min per door […]

I recently performed this small feat by not following the Haynes Manual instructions. For the driver\’s side valve cover removal the manual descibed removing the serpentine belt and the alternator in order that the valve cover could be moved forward for removal. I noticed the cover for the wiper motor at the firewall and with […]

In front of the water pump pulley on 1988 and later L98s resides a rather large 10lb steel disk, lovingly refered to as the “frisbee”. There has been much debate on the Forum about it’s purpose and the benefits/risks of removing it. During a Q & A session at Corvettes at Carlisle 2001, I posed […]

Before beginning familiarize yourself with any wiring diagrams of your starter circuit that you may have. On the existing solenoid (mounted to the starter) there are typically three (3) terminals. Depending on the year of your vehicle, either all or only two (2) will be used. Typically, non-HEI equipped vehicles will use all three terminals, […]