Go Back  CorvetteForum - Chevrolet Corvette Forum Discussion > General Corvette Topics > Audio/Electronics
Reload this Page >

How to setup new head unit with stock bose and PAC roemvet1

Notices
Audio/Electronics Stereo System Installation Info, Amplifiers, Subwoofers, Radar Detectors, Police Scanners, and CB Radios for the Corvette

How to setup new head unit with stock bose and PAC roemvet1

 
Old 04-04-2019, 11:38 AM
  #1  
sirdano
CF Senior Member
Thread Starter
 
sirdano's Avatar
 
Member Since: Jul 2015
Location: Round Rock Texas
Posts: 716
Received 69 Likes on 66 Posts
Default How to setup new head unit with stock bose and PAC roemvet1

Setup any front cross over in HU to allow full pass of signal. Rear speaker check spec. Mine could go down to 40hz so set those to full also.
Adjust fader to all up front and to one side. Turn adjustment screwa so no base. Should be counter clock.
I used a phone app connect through bluetooth to generate a signal of 100hz. App was "frequency Generator"
Set SPL C and fast response. Dial to 80db
Set volume until I could get meter to read at 80db on all speakers then put back to front left.
Set frequency generator to 40hz. Did not touch volume.
Now I started to adjust the pots in the PAC unit until the base read 80db.
Switch to right and did same thing.
Put to center and had to back them down a notch.

Now test with music. My sub are now not over power and it sound awesome. My finial adjustment is with the arrow on pot pointing down.as per picture.

sirdano is offline  
 


Thread Tools
Search this Thread
Sponsored Ads
Vendor Directory

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.
 
  • Ask a Question
    Get answers from community experts
Question Title:
Description:
Your question will be posted in: