Parts Donations For Joe Gaudette!!!
#1
Melting Slicks
Thread Starter
Parts Donations For Joe Gaudette!!!
Guys, Some of you have offered up parts to donate to Joe. Below is a list of what I know right now we need ASAP...
Front Fascia (I know OBX, I thought we didn't need it!!!)
Both front Fenders
Rear Fascia
Both rear fenders
Both Side Rocker
T1 Spec Control ARMS
Spindles
Suspension uprights
Wheel bearings for all corners
Please send ALL PARTS TO:
Joe will be coming to get donations by the end of the month, and he'll be taking back all the parts I gather with him, as he goes to Phoenix's shop.
Any questions, please contact me at dat74z@yahoo.com or PM me here and I'll check in over the next few days/weeks!
Thanks GANG!!!
Mike
Front Fascia (I know OBX, I thought we didn't need it!!!)
Both front Fenders
Rear Fascia
Both rear fenders
Both Side Rocker
T1 Spec Control ARMS
Spindles
Suspension uprights
Wheel bearings for all corners
Please send ALL PARTS TO:
Joe will be coming to get donations by the end of the month, and he'll be taking back all the parts I gather with him, as he goes to Phoenix's shop.
Any questions, please contact me at dat74z@yahoo.com or PM me here and I'll check in over the next few days/weeks!
Thanks GANG!!!
Mike
Last edited by Mikelly; 09-09-2008 at 08:58 PM.
#2
Melting Slicks
Just wanted to say great job to Mike for stepping up to the plate and volunteering his time and money to help Joe out.
What a stand up guy!
Aaron Quine
Kumho Tire (Motorsports Division)
rasrboy@hotmail.com
330-573-4338 Cell
What a stand up guy!
Aaron Quine
Kumho Tire (Motorsports Division)
rasrboy@hotmail.com
330-573-4338 Cell
#4
Drifting
Member Since: Aug 2004
Location: Bedford TX
Posts: 1,519
Likes: 0
Received 0 Likes
on
0 Posts
St. Jude Donor '06-'07
Mike,
I have 4 oe wheel hubs that I took off my 98 at about 100k miles. One rear was making noise. The others were fine, but I replaced all anyways. Do you want?
Cliff
I have 4 oe wheel hubs that I took off my 98 at about 100k miles. One rear was making noise. The others were fine, but I replaced all anyways. Do you want?
Cliff
#5
Melting Slicks
Thread Starter
Send them... We'll sort out what can and can't be used later. I believe we can get new bearings for the hubs, and if that's the case, then we can use them.
Mike
Mike