1974 Corvette, Custom Built Race Car
10-14-2010, 07:58 PM
#1
2nd Gear
Thread Starter
Member Since: Oct 2010
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
For Sale 1974 Corvette, Custom Built Race Car
Motor is a Chevrolet 350 with JE Pistons, Eagle Crank, SBC Rods, Dart heads that were polished and ported, a complete balanced assembly putting out approximately 430 horsepower. Quick fuel Q-series 750 cfm carburetor, Edlebrock performance RPM Air Gap Intake. McLeod Industries Mag Street Twin Clutch. Motor built by LJ’s Speed and Machine shop in Napa.
Shocks made by Bilsteins and they were sent back to Bilsteins for revalveing and compression work.
Front Springs are 9 ½ inch 1200 pound springs while the Rear spring is a custom built seven leaf 600 pound spring.
Transmission is a custom built Chevrolet M-20 four speed.
Rear end is a custom built Chevrolet rear end with 411 gears.
Rims American Racing 15 x 10, with Goodyear Eagle racing tires, 25 x 11 x 15.
ASKING $19,000.00 OR BEST OFFER. CONTACT MIKE WALTER, 707-449-4702 or my63vet@earthlink.net
Shocks made by Bilsteins and they were sent back to Bilsteins for revalveing and compression work.
Front Springs are 9 ½ inch 1200 pound springs while the Rear spring is a custom built seven leaf 600 pound spring.
Transmission is a custom built Chevrolet M-20 four speed.
Rear end is a custom built Chevrolet rear end with 411 gears.
Rims American Racing 15 x 10, with Goodyear Eagle racing tires, 25 x 11 x 15.
ASKING $19,000.00 OR BEST OFFER. CONTACT MIKE WALTER, 707-449-4702 or my63vet@earthlink.net
Last edited by my63vet; 11-24-2010 at 10:44 AM. Reason: lowering price
11-24-2010, 05:23 PM
#4
Safety Car
Is this an actual race car? Has it ever been raced?
Richard
Richard
11-24-2010, 07:40 PM
#6
2nd Gear
Thread Starter
Member Since: Oct 2010
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
This car has been setup as an autocross car. It has never been on a race track such as Thunderhill or Infineon. Owner will answer any questions. You can contact him at my63vet@earthink.net or by calling 707-449-4702. Thanks for your questions, Mike Walter
