Where to buy worn out 2 piece rotor? The bigger the better
#1
Safety Car
Thread Starter
Where to buy worn out 2 piece rotor? The bigger the better
I figure since most of the track guys are here, this would be the best place to ask.
It may seem like an unusual request. I'm looking to get a worn out 2 piece rotor. It can have slots, drills, or any combination of the two.
My intention is to clean it up (possibly even have it machined smooth if too bad) and use it as a base for making a coat/helmet rack. I'm in the Houston area and local is always good. Yes, I could just buy a new 2 piece 14" rotor for $500+ but that seems overkill for a simple project.
Thanks
It may seem like an unusual request. I'm looking to get a worn out 2 piece rotor. It can have slots, drills, or any combination of the two.
My intention is to clean it up (possibly even have it machined smooth if too bad) and use it as a base for making a coat/helmet rack. I'm in the Houston area and local is always good. Yes, I could just buy a new 2 piece 14" rotor for $500+ but that seems overkill for a simple project.
Thanks
#6
Safety Car
Thread Starter
I don't have much these days. Just a C6 center console lid and base (beige).
Yes, hat and ring would be preferable but I could make due with just the disc and come up with something clever for the hat.
Any chance I could get pics of said ring? I will PM you an email address.
No problem. I don't hold on to my junk forever either.
Yes, hat and ring would be preferable but I could make due with just the disc and come up with something clever for the hat.
Any chance I could get pics of said ring? I will PM you an email address.
No problem. I don't hold on to my junk forever either.
#7
Burning Brakes
I figure since most of the track guys are here, this would be the best place to ask.
It may seem like an unusual request. I'm looking to get a worn out 2 piece rotor. It can have slots, drills, or any combination of the two.
My intention is to clean it up (possibly even have it machined smooth if too bad) and use it as a base for making a coat/helmet rack. I'm in the Houston area and local is always good. Yes, I could just buy a new 2 piece 14" rotor for $500+ but that seems overkill for a simple project.
Thanks
It may seem like an unusual request. I'm looking to get a worn out 2 piece rotor. It can have slots, drills, or any combination of the two.
My intention is to clean it up (possibly even have it machined smooth if too bad) and use it as a base for making a coat/helmet rack. I'm in the Houston area and local is always good. Yes, I could just buy a new 2 piece 14" rotor for $500+ but that seems overkill for a simple project.
Thanks
Jim
#8
Race Director
Unlikely that you will find a good deal on a hat since the ability to re-use the hat is a big selling point. Unless someone has somehow damaged a hat.
#9
Safety Car
Thread Starter
#10
Supporting Vendor
Member Since: Nov 2005
Location: Supporting the Corvette Community at Abel Chevrolet in Rio Vista, CA 707-374-6317 Ext.123
Posts: 14,498
Received 1,425 Likes
on
597 Posts
St. Jude Donor '08
I have a handfull of worn out Coleman rings floating around and would be happy to send you one of the local deal falls through. I'll cover shipping and all if you show us a pic of the finished project. Shoot me a PM if you need it.
RICH
RICH