RX-Ben

Anyone ever used self-locking fasteners (or a jam nut setup) and backed off the control arm bolts to the point where the arms will rotate freely? I got this advise from a circle track builder, wondering if anyone has any thoughts about it.

Thanks.

sperkins

I'm guessing you're not talking about doing that with the stock eccentric bolts - right?
Stock rubber bushings with a camber kit?

RX-Ben

Ha!
Delrin and camber plates.

Still figuring out how to fix the binding with poly sway bushings...thinking of boring them out or heading back to stock rubbers. Teflon tape and a bunch of lube didn't do the trick.

sperkins

I'm confused. You're running delrin control arm bushings and poly sway bar bushings?

RX-Ben

Yes. Delrin control arm bushings, poly sway bar bushings.
I haven't found the sway bar bushings in delrin.