-LG Motorsports- Drop Spindles, a close up look.
#1
Former Vendor
Thread Starter
Member Since: Aug 2005
Location: Lewisville TX
Posts: 16,898
Received 406 Likes
on
300 Posts
St. Jude Donor '03-'04-'05-'06-'07-'08-'09-'10-'11-'12-'13
-LG Motorsports- Drop Spindles, a close up look.
Hey guys,
I have had a lot of interest over this summer with the Drop Spindles and have done a number of packages so much so, we sold out this summer. Not to fear, THEY HAVE RETURNED TO THE STORE!!
LG Motorsports new forged drop spindle for C5/C6/C6Z Corvette.
A must have for lowered cars! Our new drop spindle will effectively lower your car slightly more than 1" from stock while leaving the control arms in the factory locations and within GM's designed suspension curve. We have been using these on all of our World Challenge Corvette's since 2004, and are currently being used on the new GrandAm GT #28 LG Motorsports Corvette
Our drop spindles include one full set of four uprights, assembled with mono ball upper mount, pivot pin, and nut. These are 100% direct replacements for your factory unit, with no modifications required to your factory control arms, bearings, tie rods, or caliper mounts.
Don't forget about our brake ducts and SKF bearings when doing the upgrade as well!
In stock, and ready to ship for only $2995 per set of four!
Call us or your dealer today for your set!
I have had a lot of interest over this summer with the Drop Spindles and have done a number of packages so much so, we sold out this summer. Not to fear, THEY HAVE RETURNED TO THE STORE!!
LG Motorsports new forged drop spindle for C5/C6/C6Z Corvette.
$2995 FOR ALL FOUR!!
A must have for lowered cars! Our new drop spindle will effectively lower your car slightly more than 1" from stock while leaving the control arms in the factory locations and within GM's designed suspension curve. We have been using these on all of our World Challenge Corvette's since 2004, and are currently being used on the new GrandAm GT #28 LG Motorsports Corvette
Our drop spindles include one full set of four uprights, assembled with mono ball upper mount, pivot pin, and nut. These are 100% direct replacements for your factory unit, with no modifications required to your factory control arms, bearings, tie rods, or caliper mounts.
Don't forget about our brake ducts and SKF bearings when doing the upgrade as well!
In stock, and ready to ship for only $2995 per set of four!
Call us or your dealer today for your set!
#3
Drifting
I don't have a coil over system YET but I have to swap out my wheel hubs/bearings and I was thinking of doing a preemptive strike and getting these.
Do you guys have an out of state vendor so I don't have to pay the dreaded sales tax?
Jay
Do you guys have an out of state vendor so I don't have to pay the dreaded sales tax?
Jay