Painrace

I wanted to replace my throw out bearing with an upgraded one from Katech. It took my GM Master Mechanic 3.5 hours!

Here is old and new before installation:



Here is is installed:



In process:



Also stuck these in (Old and New):



Job complete in 3.5 Hours:




Jim

Werks

Looking good Jim!

redtopz

That's a nice looking throw out bearing.

I just replaced the billet diff support that was on my ST2 car with a stock rubber one because I kept having problems with my diff breaking both the gears and housing. No problems since I went back to the stock one. I'm not sure if it was just an issue for my car, but if you start hearing funny noises or seeing leaks from the diff, you might want to check it out.

slo_z28

3.5 include the alignment?

dvandentop

you will love the beefed up tranny mounts gives the car a whole new feel.

Han Solo

Hope you put a pilot bushing in place of the pilot bearing while you were in there.

froggy47

That dude is fast.



What are those old/new parts (noob question)?

rithsleeper

For a second it looked like the trans jack stand was holding the car up lol, i said "whhhhaaat!?"

That would be more dangerous than juggling gernades...

Painrace

Good idea! We will try that next time!

Jim

Painrace

No! My car is too low to fit on their alignment machine!

Jim

BgBoost1

Jim - Looks good man!!! Congrats on getting it done so quickly!!!

rustyguns

TAKES ME 5 !

Painrace

Old and new throw out bearing assembly!

New and old transmission mount.

Jim