Harness bar height
#21
Melting Slicks
Well, case closed. Found a second hand SharkBar NIB online. Install went OK however I'm not a fan of the mounting bolts to the pillar and how the OEM seat belts are not free to rotate.
May need to make some tweaks and source a longer bolt to use a sleeve to allow seat belt to rotate.
May need to make some tweaks and source a longer bolt to use a sleeve to allow seat belt to rotate.
#22
Safety Car
Thread Starter
OOOO perfect. I'll check it out.
Off the top of my head, a longer bolt, properly selected ID/OD spacer and drilling out factory seat belt would do the trick.
Edit: Looked on OG racing for that PN and no luck.
Off the top of my head, a longer bolt, properly selected ID/OD spacer and drilling out factory seat belt would do the trick.
Edit: Looked on OG racing for that PN and no luck.
Last edited by smitty2919; 02-21-2019 at 10:55 AM.
#24
Safety Car
Thread Starter
I just tried to look up that PN in general and couldn't find it regardless of C5/C6. I did find the BK install instructions. I see they use a "stepped washer".
#25
Melting Slicks
The part number I give you isn't on the website. You have to lose your hardware and call B-K with a "I lost my hardware can I buy new hardware so I can mount by bar?" and then they give you that number.
The following users liked this post:
smitty2919 (02-21-2019)
#26
Safety Car
Thread Starter
Ahhh got ya. Thank you