FS: 1964 Convertible 327/365 HP $47,500
#1
Advanced
Thread Starter
1964 Convertible 327/365 HP $47,500
Very clean inside and out. 90% restored and upgraded to make a nice daily driver, or could be restored to all original. Disk breaks added. Power steering added (for those who know, it has a different oil pan to accommodate the power steering). It is not numbers matching. A counter exchange engine was put in about 1967. But it's still a 365hp, 4 speed manual car and engine as it was when it rolled off the assembly line.
Positives
+ Frame very clean.
+ Newer convertible top (White)
+ Restro Mod Radio — Wonderbar in box.
+ All new rubber on suspension and mounts.
+ All gauges work.
+ Engine runs very nice.
+ Comes with restoration manuals and some parts.
Negatives
- Paint is a 4 footer...looks good, but, to be really nice it's going to need a paint job.
- Blower fan stopped working... not 100% sure why yet.
I'm selling because I picked up a 1958 Corvette that I plan to restore and can only have one toy at a time. :-) This is a very nice vette. I've driven it on longer trips and around town with no issues. If you have any questions, please PM... Thanks! Less
Positives
+ Frame very clean.
+ Newer convertible top (White)
+ Restro Mod Radio — Wonderbar in box.
+ All new rubber on suspension and mounts.
+ All gauges work.
+ Engine runs very nice.
+ Comes with restoration manuals and some parts.
Negatives
- Paint is a 4 footer...looks good, but, to be really nice it's going to need a paint job.
- Blower fan stopped working... not 100% sure why yet.
I'm selling because I picked up a 1958 Corvette that I plan to restore and can only have one toy at a time. :-) This is a very nice vette. I've driven it on longer trips and around town with no issues. If you have any questions, please PM... Thanks! Less
Last edited by Popeye206; 06-02-2018 at 08:22 AM.
#2
Pro
Four wheel disc brakes, or disc/drum?
Solid lifter cam?
Solid lifter cam?
#3
Advanced
Thread Starter
#4
Pro
Are the colors (int/ext) original to the trim tag codes?
#5
Advanced
Thread Starter
The following users liked this post:
EnfieldJoe (06-03-2018)