Poorly fitting C2 headlight bezels
#1
Instructor
Thread Starter
Poorly fitting C2 headlight bezels
Doing some prep work on a 1965 C2 headlight bezel, upper corners. I noticed the steel bezels are protruding beyond the aluminum cover corners, on either side when the headlights are in a closed position. Just wondering if this is a common occurrence and what’s the best resolution? Was thinking about adding a weld to the inside of either corner on the steel bezel and then just grind off the outer edges to match the aluminum cover.
#3
1967 Pedal Car Champion
Considering that you must have your motors disconnected to allow the doors to swing in that direction, I think that is exaggerating the two parts. In your pics where the doors are closed, I think they look good. Also keep in mind that both parts should be painted the same body color, so that will help disguise what you are seeing.
The following 2 users liked this post by 4 Speed Dave:
ChrisBlair (11-18-2023),
dcamick (11-18-2023)