Is this VIN/trim tag and block stamp real?
01-09-2012, 12:08 PM
#21
Team Owner
Member Since: Oct 2000
Location: Washington Michigan
Posts: 38,899
Received 1,857 Likes
on
1,100 Posts
John,
A techinicality, but I believe they did use rotary mills on the W block engines at Tonawanda /CFD. Don't know for sure, but I suspect the 74 deg angle didn't work with the broach mill. I've never seen a W block without the rotary marks including several NOS examples.
A techinicality, but I believe they did use rotary mills on the W block engines at Tonawanda /CFD. Don't know for sure, but I suspect the 74 deg angle didn't work with the broach mill. I've never seen a W block without the rotary marks including several NOS examples.
