. . If It's Not One Thing, , ,
#1
Intermediate
Thread Starter
. . If It's Not One Thing, , ,
. .
. . The six blade fan came in so decided it's time to install it and replace the 8" balancer that has been causing so much timing confusion. . Got the fan on and it barely goes into the shroud. . At least a full inch from being half way. .
. . Then the balancer. . Good thing I changed it. . Can't believe what some people do on a car. . This balancer was junk. . Loose on the crank shaft and the keyway was wobbled out to almost twice the normal size. . When I removed the center bolt the balancer actually dropped. . Reached up and slid it off. .
. . Then the replacement balancer. . Get it on. . Nice and tight. . But the pulley is now half a groove from matching the water pump pulley above it. .
. .
. . The six blade fan came in so decided it's time to install it and replace the 8" balancer that has been causing so much timing confusion. . Got the fan on and it barely goes into the shroud. . At least a full inch from being half way. .
. . Then the balancer. . Good thing I changed it. . Can't believe what some people do on a car. . This balancer was junk. . Loose on the crank shaft and the keyway was wobbled out to almost twice the normal size. . When I removed the center bolt the balancer actually dropped. . Reached up and slid it off. .
. . Then the replacement balancer. . Get it on. . Nice and tight. . But the pulley is now half a groove from matching the water pump pulley above it. .
. .
#2
Team Owner
Member Since: Feb 2003
Location: Sitting in his Nowhere land Hanover Pa
Posts: 48,995
Received 6,937 Likes
on
4,779 Posts
2015 C2 of Year Finalist
Go with a odd number of blades on a fan Unless you like unneeded noise. You might have some wrong pulleys
The following users liked this post:
hdcoloC1 (07-23-2017)
#3
Race Director
Member Since: Jun 2006
Location: Inverness FL
Posts: 17,891
Received 727 Likes
on
621 Posts
St. Jude Donor '07
off which way? if the water pump pulley is 'in', then this might be enough...
http://www.parts123.com/corvettecent...50e&ukey=30549
or, if the water pump pulley is 'out'. you might be missing this:
http://www.parts123.com/corvettecent...50e&ukey=29253
Bill
Bill
http://www.parts123.com/corvettecent...50e&ukey=30549
or, if the water pump pulley is 'out'. you might be missing this:
http://www.parts123.com/corvettecent...50e&ukey=29253
Bill
Bill
The following users liked this post:
hdcoloC1 (07-23-2017)
#5
Intermediate
Thread Starter
. . noise
. . This is a 1962 Corvette, I doubt that I will hear the fan over the rest of the car. . (insert smile emoji here) . .
. . Yes the pulley that was on there is not right. . Have two others. . One was to large diameter (big block?) and the other stuck out half a groove the other way. . Nuts. .
. . Yes the pulley that was on there is not right. . Have two others. . One was to large diameter (big block?) and the other stuck out half a groove the other way. . Nuts. .