Backplate for heat exchanger box
#1
Instructor
Thread Starter
Backplate for heat exchanger box
Hi
I'm renovating my heat exchanger box and noticed that the part of the back plate that has the fastener that goes above the gas pedal is bent. Is this the way it should be, or should I straighten it? My car is at another location so I cannot check for myself.
I'm renovating my heat exchanger box and noticed that the part of the back plate that has the fastener that goes above the gas pedal is bent. Is this the way it should be, or should I straighten it? My car is at another location so I cannot check for myself.
#2
Race Director
Member Since: Jan 2002
Location: Close to DC
Posts: 14,534
Received 2,126 Likes
on
1,465 Posts
C2 of the Year Finalist - Modified 2020
What you have is correct. DO NOT bend it. Dennis
#4
Instructor
Thread Starter
If you look at my picture, it's the plate that is horizontal. Not the bracket that is fastened to it that I'm worried about.