[C2] Smokie Yunick 327 tri power
#63
Race Director
Member Since: Feb 2007
Location: northern california
Posts: 13,613
Received 6,530 Likes
on
3,004 Posts
C2 of Year Finalist (track prepared) 2019
#66
Team Owner
Barry Grant had a set up like this also (his own manifold and carbs)!
Last edited by TCracingCA; 02-18-2018 at 10:22 AM.
#68
Race Director
cool thanks! I know he was developing a manifold to feed those Hemi heads! I think I remember a picture of the GM Trans Am Z-28 intake on a Hemi headed engine. Thus we are looking now for a missing link round port intake of some Smokey variation! I will have to look into that! I have an article on a J-56 disc brake Camaro with a Hemi headed small block and I think that showed the heads and intake! Wish I knew were that was, to see if round or square!
http://www.ricksclassics.com/one/00-One/cortez.html
This car belongs to Rick George, formerly the owner of Rick's Camaros, and current owner of Classic Headquarters.
The following users liked this post:
Westlotorn (02-19-2018)
#69
Team Owner
Is the J-56, Hemi head Z/28 you were thinking about?
http://www.ricksclassics.com/one/00-One/cortez.html
This car belongs to Rick George, formerly the owner of Rick's Camaros, and current owner of Classic Headquarters.
http://www.ricksclassics.com/one/00-One/cortez.html
This car belongs to Rick George, formerly the owner of Rick's Camaros, and current owner of Classic Headquarters.
I just looked and those Rick guys got the Silver one and put it thru a whole restoration. The yellow one shows up! And will have to spend more time looking later!
I got busy busy this weekend and didn't crack any of the books on these subjects yet!
Last edited by TCracingCA; 02-19-2018 at 11:41 AM.
The following 5 users liked this post by Clifton81:
Dr L-88 (03-05-2018),
midvette6067 (03-07-2018),
ptjsk (04-25-2021),
scotty t (03-05-2018),
Sky65 (06-19-2019)
#71
Race Director
Member Since: Jun 2006
Location: Inverness FL
Posts: 17,891
Received 727 Likes
on
621 Posts
St. Jude Donor '07
congratulations... hope it works well on your engine
did it supposedly require any cam/compression/timing modifications in order to develop its potential; or, back in the day, did it just turn out to be eye candy?
Bill
did it supposedly require any cam/compression/timing modifications in order to develop its potential; or, back in the day, did it just turn out to be eye candy?
Bill
#72
Safety Car
Member Since: Nov 2000
Location: Clinton Township MI
Posts: 4,750
Received 119 Likes
on
98 Posts
Cruise-In III Veteran
Clifton81,
Welcome!
Very cool!
Like Bill, I too would like to know how the driveability with this setup is. More pics of your car AND the build of your small block would really be appreciated.
Thanks in advance!
Regards,
Jim
In God We Trust!
Welcome!
Very cool!
Like Bill, I too would like to know how the driveability with this setup is. More pics of your car AND the build of your small block would really be appreciated.
Thanks in advance!
Regards,
Jim
In God We Trust!
#73
Race Director
Member Since: Mar 2001
Location: Mustang OK
Posts: 13,852
Received 3,772 Likes
on
1,674 Posts
2023 C1 of the Year Finalist - Modified
2015 C1 of the Year Finalist
#77
Team Owner
Member Since: Nov 2005
Location: Beach & High Desert Southern California
Posts: 25,501
Received 2,346 Likes
on
891 Posts
Under the front fuel bowl should be a GM part number with a "-0" suffix (or prefix, CRS kicking in).
It was not a factory installed option, so value added to the car is questionable unless there is receipts of documented installation by a dealer or backdoor shop authorized by GM. It is however a nice addition to the engine bay, and will cost well over $1,200 to duplicate with similar carbs on the Edelbrock clone. To a GM collector the set could be worth twice that value, or more (but not $10,000, they did not add that much in performance).
Buyers set the market, but the value is the manifold and carbs, not a unique car (unless you have documentation).
Did you pitch an offer to buy the car?
#78
Race Director
Member Since: Mar 2001
Location: Mustang OK
Posts: 13,852
Received 3,772 Likes
on
1,674 Posts
2023 C1 of the Year Finalist - Modified
2015 C1 of the Year Finalist
I can easily believe that someone would buy the car just to get the Tri-power setup. Since the air cleaner is a one of a kind, that's GOT TO bring big $$$$$.
#80
Team Owner
Member Since: Apr 2008
Location: Coloring within the lines
Posts: 27,343
Received 1,920 Likes
on
1,333 Posts
So the next time some guy comes up and says "I knew a guy that had a small block tri-power/3 deuces."
Last edited by Easy Rhino; 03-06-2018 at 05:53 AM.