Notices
C3 General General C3 Corvette Discussion not covered in Tech
Sponsored by:
Sponsored by:

Pics of my 1969 Stingray

 
Old 07-07-2011, 10:25 AM
  #41  
BOSTONCAMARO
CF Senior Member
Thread Starter
 
BOSTONCAMARO's Avatar
 
Member Since: May 2006
Location: Lynn MA
Posts: 3,180
Thanks: 0
Thanked 4 Times in 4 Posts
Default

My friend Rob worked the adjuster - his car/truck that he has since sold was a 500hp small block, M22 Rockcrusher, 12 bolted, lowered S 10 that was a mid 11 second car

BOSTONCAMARO is offline  
Old 07-07-2011, 10:26 AM
  #42  
BOSTONCAMARO
CF Senior Member
Thread Starter
 
BOSTONCAMARO's Avatar
 
Member Since: May 2006
Location: Lynn MA
Posts: 3,180
Thanks: 0
Thanked 4 Times in 4 Posts
Default

BOSTONCAMARO is offline  
Old 07-07-2011, 10:27 AM
  #43  
BOSTONCAMARO
CF Senior Member
Thread Starter
 
BOSTONCAMARO's Avatar
 
Member Since: May 2006
Location: Lynn MA
Posts: 3,180
Thanks: 0
Thanked 4 Times in 4 Posts
Default

The leveler/pitch adjustment made this a snap, even when almost on the motor mounts all the way, we adjusted it for the last time, eased right in

BOSTONCAMARO is offline  
Old 07-07-2011, 10:27 AM
  #44  
BOSTONCAMARO
CF Senior Member
Thread Starter
 
BOSTONCAMARO's Avatar
 
Member Since: May 2006
Location: Lynn MA
Posts: 3,180
Thanks: 0
Thanked 4 Times in 4 Posts
Default

Nothing fancy, just a quickie clean up and paint

BOSTONCAMARO is offline  
Old 07-07-2011, 10:28 AM
  #45  
BOSTONCAMARO
CF Senior Member
Thread Starter
 
BOSTONCAMARO's Avatar
 
Member Since: May 2006
Location: Lynn MA
Posts: 3,180
Thanks: 0
Thanked 4 Times in 4 Posts
Default

BOSTONCAMARO is offline  
Old 07-07-2011, 10:29 AM
  #46  
BOSTONCAMARO
CF Senior Member
Thread Starter
 
BOSTONCAMARO's Avatar
 
Member Since: May 2006
Location: Lynn MA
Posts: 3,180
Thanks: 0
Thanked 4 Times in 4 Posts
Default

Even though it was midnight when we finished, Rob offered to pull the plugs to get ready for the header install, as I finished cleaning up the barn

BOSTONCAMARO is offline  
Old 07-07-2011, 10:45 AM
  #47  
arkus
CF Senior Member
 
arkus's Avatar
 
Member Since: Jan 2008
Location: CA
Posts: 3,143
Thanked 3 Times in 3 Posts
Default

looks good .
looks like a strong motor
arkus is offline  
Old 07-07-2011, 10:57 AM
  #48  
BOSTONCAMARO
CF Senior Member
Thread Starter
 
BOSTONCAMARO's Avatar
 
Member Since: May 2006
Location: Lynn MA
Posts: 3,180
Thanks: 0
Thanked 4 Times in 4 Posts
Default

The motor is like 10.5 to 10.75 to 1, has fully, heavily port 186 casting number heads, screw in studs, guide plates, full ported and flowbenched Victor Junior and Crane Fireball II 302H with 302 duration480" lift. It was a 12 second motor in the Green Camaro and that car always needed a little more gear, it had 3:73's. The Corvette has 4:11's so I am sure it will go good and be dependable.

Glad you like the pics!
BOSTONCAMARO is offline  
Old 07-07-2011, 11:39 AM
  #49  
Deacon Don
CF Senior Member
 
Deacon Don's Avatar
 
Member Since: Nov 2010
Location: Vilonia Arkansas
Posts: 296
Thanks: 0
Thanked 0 Times in 0 Posts
Default

nice!
Deacon Don is offline  
Old 07-07-2011, 02:53 PM
  #50  
BOSTONCAMARO
CF Senior Member
Thread Starter
 
BOSTONCAMARO's Avatar
 
Member Since: May 2006
Location: Lynn MA
Posts: 3,180
Thanks: 0
Thanked 4 Times in 4 Posts
Default

thanks, just nice to see the car getting some attention, the car only has 53k on it but had a very tough life
BOSTONCAMARO is offline  
Old 07-12-2011, 10:53 PM
  #51  
BOSTONCAMARO
CF Senior Member
Thread Starter
 
BOSTONCAMARO's Avatar
 
Member Since: May 2006
Location: Lynn MA
Posts: 3,180
Thanks: 0
Thanked 4 Times in 4 Posts
Default

Went to go buy sidepipes off a guy, didnt buy them but did buy this L 88 scooped hood, needs some work, but not bad, not an original GM piece, but will work fine

BOSTONCAMARO is offline  
Old 07-12-2011, 10:53 PM
  #52  
BOSTONCAMARO
CF Senior Member
Thread Starter
 
BOSTONCAMARO's Avatar
 
Member Since: May 2006
Location: Lynn MA
Posts: 3,180
Thanks: 0
Thanked 4 Times in 4 Posts
Default

BOSTONCAMARO is offline  
Old 07-18-2011, 11:17 AM
  #53  
BOSTONCAMARO
CF Senior Member
Thread Starter
 
BOSTONCAMARO's Avatar
 
Member Since: May 2006
Location: Lynn MA
Posts: 3,180
Thanks: 0
Thanked 4 Times in 4 Posts
Default





BOSTONCAMARO is offline  
Old 07-18-2011, 11:20 AM
  #54  
BOSTONCAMARO
CF Senior Member
Thread Starter
 
BOSTONCAMARO's Avatar
 
Member Since: May 2006
Location: Lynn MA
Posts: 3,180
Thanks: 0
Thanked 4 Times in 4 Posts
Default

BOSTONCAMARO is offline  
Old 08-23-2011, 10:23 AM
  #55  
BOSTONCAMARO
CF Senior Member
Thread Starter
 
BOSTONCAMARO's Avatar
 
Member Since: May 2006
Location: Lynn MA
Posts: 3,180
Thanks: 0
Thanked 4 Times in 4 Posts
Default

BOSTONCAMARO is offline  
Old 08-23-2011, 10:24 AM
  #56  
BOSTONCAMARO
CF Senior Member
Thread Starter
 
BOSTONCAMARO's Avatar
 
Member Since: May 2006
Location: Lynn MA
Posts: 3,180
Thanks: 0
Thanked 4 Times in 4 Posts
Default

BOSTONCAMARO is offline  
Old 08-23-2011, 10:24 AM
  #57  
BOSTONCAMARO
CF Senior Member
Thread Starter
 
BOSTONCAMARO's Avatar
 
Member Since: May 2006
Location: Lynn MA
Posts: 3,180
Thanks: 0
Thanked 4 Times in 4 Posts
Default

Dropped back out, so I could put header gaskets in after test fit

BOSTONCAMARO is offline  
Old 08-23-2011, 10:26 AM
  #58  
BOSTONCAMARO
CF Senior Member
Thread Starter
 
BOSTONCAMARO's Avatar
 
Member Since: May 2006
Location: Lynn MA
Posts: 3,180
Thanks: 0
Thanked 4 Times in 4 Posts
Default

Trimmed one of the tabs that stick down below the door, I think for rocker panel moulding, seemed to get in the way of the sidepipe tab when going in.

One inch header bolts, stainless allen bolts sitting in place.

BOSTONCAMARO is offline  
Old 08-23-2011, 10:26 AM
  #59  
BOSTONCAMARO
CF Senior Member
Thread Starter
 
BOSTONCAMARO's Avatar
 
Member Since: May 2006
Location: Lynn MA
Posts: 3,180
Thanks: 0
Thanked 4 Times in 4 Posts
Default

BOSTONCAMARO is offline  
Old 08-23-2011, 10:26 AM
  #60  
BOSTONCAMARO
CF Senior Member
Thread Starter
 
BOSTONCAMARO's Avatar
 
Member Since: May 2006
Location: Lynn MA
Posts: 3,180
Thanks: 0
Thanked 4 Times in 4 Posts
Default

Bolts all in.

BOSTONCAMARO is offline  

Thread Tools
Search this Thread
Quick Reply: Pics of my 1969 Stingray


Sponsored Ads
Vendor Directory

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.
 
  • Ask a Question
    Get answers from community experts
Question Title:
Description:
Your question will be posted in: