Re: Looking for some help here
Thread Starter
Instructor
Joined: Dec 2010
Posts: 149
Likes: 0
From: Southgate Michigan
Re: Looking for some help here
Hi to everyone:
Forum's been good to me so far
So I'm again looking for someone to help me out. 
I just rebuilt my complete power steering system. Well, after bleeding it out, I still don't have any Power Streeing at all. The valve seems centered, as it never went to the right or left violently like everyone sez it will if the valve is off centered, when I started it. All of the lines are routed correctly. But, I still have NO power steering. One other thing, I'm using an aftermarket Pump with a remote reservoir. Has anyone had any experience using a different pump with the steering linkage?
Any Suggestions as to where to start looking? Starting to pull my hair out over this.
Forum's been good to me so far
So I'm again looking for someone to help me out. I just rebuilt my complete power steering system. Well, after bleeding it out, I still don't have any Power Streeing at all. The valve seems centered, as it never went to the right or left violently like everyone sez it will if the valve is off centered, when I started it. All of the lines are routed correctly. But, I still have NO power steering. One other thing, I'm using an aftermarket Pump with a remote reservoir. Has anyone had any experience using a different pump with the steering linkage?Any Suggestions as to where to start looking?
Starting to pull my hair out over this.
Last edited by Cruisin Davey G; Nov 21, 2011 at 06:49 PM. Reason: Added Picture
Thread Starter
Instructor
Joined: Dec 2010
Posts: 149
Likes: 0
From: Southgate Michigan
Thread Starter
Instructor
Joined: Dec 2010
Posts: 149
Likes: 0
From: Southgate Michigan
Re: Looking for some help here
Yeah, we're still working on it [my son & I] & yes, it's running an Air Management System [Air Lift]. I'm beginning to believe that nobody's doing what my son & I are doing to this 'Vette. I know March Pulleys in Florida, puts out a pulley system that fits a C3 Vette, but so far, I haven't run into anybody with one on theirs. Mine is made by 'Zoops', out of California. These guys been great to me & I would recommend their pruducts, in a heartbeat. But, they, like others, don't know too much about using this pulley system with a factory C3 steering set-up. They're use to running this pulley system on 'rack & pinion' set-ups. Like in Street Rods & such. Thanks for your reply !
