My 1973 Frame off Follow along the Restration
The following users liked this post:
Tim 1973 (08-30-2017)
#385
Burning Brakes
Thread Starter
#386
Instructor
I swear that somewhere in an earlier posting that your engine covers were already painted a maroon color? Too many nights laying awake at night must have changed the plan?
Love the blue! Should really pop in the sun
Jeff
Love the blue! Should really pop in the sun
Jeff
#388
Instructor
If I had a nickel for every time I changed my mind, my car would be finished! Like you once posted about being"wired differently", so am I, moving from task to task with no real sense. I figured as long as I keep making progress, eventually the car will be done!
keep up the good work
Jeff
keep up the good work
Jeff
The following users liked this post:
Tim 1973 (08-30-2017)
#389
Burning Brakes
Thread Starter
Well all I'm on my final week in Washington State. I will be headed back to Texas on Friday. Wife tells me I have a pile of parts that has come in. I will have about 2 weeks before I head out again. So I'm hoping to get some of the parts on and some paint prep done.
Tim
Tim
#391
Intermediate
Great thread! thanks for sharing. if you could maybe post info on where u got some of those parts like that tail shaft and climate control system that would be cool. everything looks really good cant wait to see it finished. Thanks!!!
#392
Burning Brakes
Thread Starter
Tim
#393
Burning Brakes
Thread Starter
I will try to post this info as I move foward.
Thanks
Tim
#396
Burning Brakes
Thread Starter
Today I worked on the rocker covers, the screw's that hold the covers onto the rockers all broke off and rusted into the metal channel that goes over the frame.
I purchased the Rocker repair kit from Ecklers
First step was to cut the screws flush. Using a center punch I then got a good mark to keep the drill on the screw. I went in 3 steps small to larger holes to bring it up to the size needed for the adapter in the repair kit.
I purchased the Rocker repair kit from Ecklers
First step was to cut the screws flush. Using a center punch I then got a good mark to keep the drill on the screw. I went in 3 steps small to larger holes to bring it up to the size needed for the adapter in the repair kit.
The following users liked this post:
caskiguy (10-08-2017)
#399
Instructor
Last Night I decided to make the Fan wiring. I used 2 cube relays with simple wiring. I have attached the wiring schamitc. The trigger just grounds out the 85 connector. Mine is set to start Fan1 at 182 and Fan 2 at 192. I will see if this works or adjust the settings later. If the AC is turned on both fans will be triggered. On my system its triggered from the ECM but could do the same with sending units and AC control switch.
#400
Burning Brakes
Thread Starter
Hey Tim, I'll be interested to see if this works OK, because on my setup fan1 will only be triggered (via the BCM-ECU) if a set of specific conditions are met, fan2 will then only be triggered (by the ECU) if fan1 is on and another set of conditions are met. I have not yet found anyone who can reprogram the ECU to change the settings for the fans.
Tim