Show me your exhaust system
#4
Nam Labrat
Member Since: Sep 2013
Location: New Orleans Loo-z-anna
Posts: 33,892
Received 4,173 Likes
on
2,735 Posts
I thought you could use a good laugh----2 inch diameter "straight" exhausts from manifold to Harley Davidson mufflers.......(Imagine four Harleys sitting side by side with deep-tone mufflers---since a Harley engine is basically an "aircooled-slice" of a 327cu.in. SBC engine LOL)
The under-differential look is temporary until the rest of the project is finished.
The under-differential look is temporary until the rest of the project is finished.
Last edited by doorgunner; 12-16-2013 at 09:18 AM.
#5
Melting Slicks
#7
I should post more photos on my exhaust but here is a link to a post when I started my exhaust system.
http://forums.corvetteforum.com/c3-t...st-system.html
http://forums.corvetteforum.com/c3-t...st-system.html
#10
Team Owner
#12
Drifting
Thread Starter
I thought you could use a good laugh----2 inch diameter "straight" exhausts from manifold to Harley Davidson mufflers.......(Imagine four Harleys sitting side by side with deep-tone mufflers---since a Harley engine is basically an "aircooled-slice" of a 327cu.in. SBC engine LOL)
The under-differential look is temporary until the rest of the project is finished.
The under-differential look is temporary until the rest of the project is finished.
#13
Nam Labrat
Member Since: Sep 2013
Location: New Orleans Loo-z-anna
Posts: 33,892
Received 4,173 Likes
on
2,735 Posts