Wire Crimpers for Packard 56 Terminals
10-09-2016, 10:31 AM
#1
Melting Slicks
Thread Starter
Member Since: May 2015
Location: Cape Girardeau Missouri
Posts: 2,365
Received 427 Likes
on
377 Posts
Wire Crimpers for Packard 56 Terminals
If you need a low cost, occasional use tool to make high quality connections for our cars check out:
http://www.sargenttools.com/ToolsByT...re_crimp_tool/
http://www.sargenttools.com/ToolsByT...re_crimp_tool/
10-09-2016, 06:46 PM
#2
Race Director
I have pair quite similar...and also the pliers and dies for the metri-pac and weatherpac terminals.
The tool you showed does work well for me. But I come across situations where it is not quite right....but has been a really good tool nonetheless.
DUB
The tool you showed does work well for me. But I come across situations where it is not quite right....but has been a really good tool nonetheless.
DUB
