My 74 restoration, 396 stroker
#81
Race Director
it may be a pain without a choke on cold days. last I checked, you get a few of those in Sweden. beautiful car.
Last edited by derekderek; 11-08-2017 at 04:23 PM.
#82
Le Mans Master
Thread Starter
Actually but has been really easy to start, been out a couple of times and started it in 0C
Just 1 long pump on the gas and it starts nicely
Just 1 long pump on the gas and it starts nicely
#83
Le Mans Master
Thread Starter
https://m.facebook.com/story.php?sto...00002938624285
Don't know if you can see this but it was the last ride before snow..
Alittle bad grip
Don't know if you can see this but it was the last ride before snow..
Alittle bad grip
#84
Race Director
https://m.facebook.com/story.php?sto...00002938624285
Don't know if you can see this but it was the last ride before snow..
Alittle bad grip
Don't know if you can see this but it was the last ride before snow..
Alittle bad grip
#88
Le Mans Master
Thread Starter
Hello now I'm awake
Gonna see if I can fix that, it's a Facebook video from a friend so I can maybe be difficult
Not so much to see, a quick 1.2.3 burn at a traffic stop
Gonna see if I can fix that, it's a Facebook video from a friend so I can maybe be difficult
Not so much to see, a quick 1.2.3 burn at a traffic stop
#89
Le Mans Master
Thread Starter
Im really happy now, I was contacted by a big car magazine here in sweden, gonna be a article about my car
I don't think it's a big article but im really happy anyways
I don't think it's a big article but im really happy anyways
#93
Le Mans Master
Thread Starter
#95
Racer
How’d you do the stainless trim? I’m in the exact type of project you’re doing. Just a little behind where you’re at! But my Fiberglass has chips along the edge also.
#97
Le Mans Master
Thread Starter
Started on my electric fan conversion this week, bought 2 12" fans with 1350cfm each, have removed all the old stuff now and made a holder for them out of 3mm aluminum, gonna paint it black later on
First try didn't go as I liked..
I cut the holes for the fans wrong didn't think the a-arm would be in the way but it is..
Needed to move the to the right more..
That's were the need to be..
New one made
First try didn't go as I liked..
I cut the holes for the fans wrong didn't think the a-arm would be in the way but it is..
Needed to move the to the right more..
That's were the need to be..
New one made