WTB 69 driver side fender center of wheel well forward
#1
Heel & Toe
Thread Starter
Member Since: Nov 2007
Location: Holmes Pa
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
WTB 69 driver side fender center of wheel well forward
I need to piece in a section of the nose on my 69. I can buy a hand laid piece, but would like press molded if possible. center of wheel well forward or a little less would be OK. PM me or e-mail Tony sharkskin69-vettehead@yahoo.com thanks. If no is there anywhere in the northeast (Philadelphia area) where I could look? Thanks
#2
Team Owner
Member Since: Jun 2000
Location: Southbound
Posts: 38,928
Likes: 0
Received 1,469 Likes
on
1,248 Posts
Cruise-In II Veteran
FWIW: replace the entire fender. You won't have a bonding seam in the fender well.
#3
Heel & Toe
Thread Starter
Member Since: Nov 2007
Location: Holmes Pa
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
I appreciate the advice, the hood surround has already been sectioned by previous owner. Very clean job. I had to reattach the surround corners @ the windshield frame due to windshield frame repair and I am considering replacing the entire front at some point when finances are better so I am not really too concerned about the bonding seam in the fender well right now. Also I think I can sand it down somewhat so that it is not obvious.