for sale. 383 stroker motor
#1
Heel & Toe
Thread Starter
Member Since: Jan 2008
Location: Houston TX
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
for sale. 383 stroker motor
I'm looking to go to a big block in my truck, so now im going to have the motor sitting around.
Its a 1986 and newer 350 block 4 bolt main that is bored out .030.
Eagle cast stroker internal balance crank with a one piece rear main seal and I beam rods with Keith black Hypereutectic pistons. professionally computer balanced rotating assembly.
Comp cams Big ***** Thumpa Retro fit hydraulic roller cam .531in .519ex lift.
Crane Cams retro fit hydraulic roller liters, double roller timing chain.
Summit racing aluminum straight plug heads 200cc intake 64cc combustion chambers.
2.020 intake valves, 1.60 exhaust valves, 3/8" rocker studs, 5/16" pushrod guideplates.
.600" lift roller double springs.
Summit racing aluminum 1.5 roller rockers
Weiand Excellerator single plain aluminum intake.
Stroker 7qt. oil pan w/ one peice oil pan gasket.
the whole setup is running 9.7:1 compression ratio. and only has roughly 10 hrs total running time. Long enough to do the cam burn and running to tune it before pulling it out of my car.
Ive got over $6000 invested in the motor.
asking $3000 shoot me pm or email me at golem_72@yahoo.com
Its a 1986 and newer 350 block 4 bolt main that is bored out .030.
Eagle cast stroker internal balance crank with a one piece rear main seal and I beam rods with Keith black Hypereutectic pistons. professionally computer balanced rotating assembly.
Comp cams Big ***** Thumpa Retro fit hydraulic roller cam .531in .519ex lift.
Crane Cams retro fit hydraulic roller liters, double roller timing chain.
Summit racing aluminum straight plug heads 200cc intake 64cc combustion chambers.
2.020 intake valves, 1.60 exhaust valves, 3/8" rocker studs, 5/16" pushrod guideplates.
.600" lift roller double springs.
Summit racing aluminum 1.5 roller rockers
Weiand Excellerator single plain aluminum intake.
Stroker 7qt. oil pan w/ one peice oil pan gasket.
the whole setup is running 9.7:1 compression ratio. and only has roughly 10 hrs total running time. Long enough to do the cam burn and running to tune it before pulling it out of my car.
Ive got over $6000 invested in the motor.
asking $3000 shoot me pm or email me at golem_72@yahoo.com
Last edited by slowstang98; 06-14-2009 at 09:14 AM.
#5
Heel & Toe
Thread Starter
Member Since: Jan 2008
Location: Houston TX
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Unfortunately, I didn't have it dyno'd. I removed it from the car before I had a chance to run it down. I know what I think it makes after tons of research but nothing concrete.