tfringo

I am looking for a pair of used original seat belt reinforcement plates for 68 corvette. I need the one's that have the square nut welded on the bottom side. These are also the ones that have the lap belt anchored to them under the seat.

Send a PM if you can help out.

avalonjohn

Hi Terry,

Did 68s have the 4 holes on those doodads?

tfringo

I went and looked at the. They had 8 holes. They are essentially square but not square. One side of the square wraps up the side of the fiberglass. So, you cant see the rivet holes there unless you feel for them. There are two rivet holes for each side of the square except for the side that wraps up and there are two rivets there also. So, 8 holes. There is a square nut tack welded to the middle area. That is where the seat belt retractor thingy bolts to. Thanks! Terry