FS: 1976 Corvette Manual Frame/Partial Rolling Chassis
10-03-2018, 04:01 PM
#1
Drifting
Thread Starter
1976 Corvette Manual Frame/Partial Rolling Chassis
Partial rolling chassis for a 1976 manual car. Frame seems very solid, only surface rust. No rot in the usual areas. Car was apparently lightly hit in the front end and a frame shop said the front bumper mounting points would need to be corrected a small amount. No rear differential which is why the rear is sitting low, but it is able to roll around. Also comes with the front bumper structure assembly, rear differential mounting bar and I will throw in a rear spring and sway bar since they were removed. Looking for $700 OBO, picked up in Charlotte, MI. I have it loaded on my trailer and could deliver within reason for some extra money.
I tried to get pictures of all the typical areas people want to look at.
I tried to get pictures of all the typical areas people want to look at.
Last edited by chazde3; 10-12-2018 at 09:08 AM.
12-07-2018, 10:26 PM
#5
Drifting
Thread Starter
04-17-2019, 07:20 AM
#7
Senior Member
Member Since: Jan 2008
Location: Easton, PA
Posts: 12,154
Received 2,031 Likes
on
1,103 Posts
St. Jude Donor '10
I'll come and get it Chuck. Have use of it now for another project. Will confirm time and date soon. Thank you. David
04-17-2019, 08:23 AM
#8
Drifting
Thread Starter