WTB: Oil pressure line fitting to block.
#1
Melting Slicks
Thread Starter
Oil pressure line fitting to block.
Looking for the threaded brass oil line fitting for a big block. This is the larger one that screws in above the oil filter. The center is tapped for the oil line to screw into it. If you think you have one, send a PM. Thanks.
Last edited by tfringo; 12-11-2018 at 05:00 PM. Reason: update notification
#2
Safety Car
should be standard 1/4" NPT into block, ... with 1/8" compression fitting for oil line.
choose a plumbing supplier.
choose a plumbing supplier.
The following users liked this post:
tfringo (12-13-2018)
#3
Melting Slicks
Thread Starter
ttt
#4
Melting Slicks
Thread Starter
I wanted to find an original just in case there was something unique to it. But, I might end up going that way. Thanks, Terry
The following users liked this post:
tfringo (12-12-2018)
The following users liked this post:
tfringo (12-12-2018)
#7
Melting Slicks
Thread Starter
Fitting
I
Thanks, but no. I was hoping to avoid buying a reproduction. The one I am looking for looks like a threaded plug with a hole drilled/tapped in the middle to accept the oil pressure line fitting. They do sell them in reproduction but I wasn't certain if they have any special markings on them. It is the one in the left lower of the photo that the 45 degree fitting is screwed into. It looks like a common fitting. Thanks
Thanks, but no. I was hoping to avoid buying a reproduction. The one I am looking for looks like a threaded plug with a hole drilled/tapped in the middle to accept the oil pressure line fitting. They do sell them in reproduction but I wasn't certain if they have any special markings on them. It is the one in the left lower of the photo that the 45 degree fitting is screwed into. It looks like a common fitting. Thanks
Last edited by tfringo; 12-12-2018 at 10:32 AM. Reason: add photo
#8
Melting Slicks
Thread Starter
Fitting
Looks like this..