FS: 70-76 LH Deluxe Door Panel GM
12-28-2018, 03:03 PM
#1
Drifting
Thread Starter
70-76 LH Deluxe Door Panel GM
I have a spare driver side door panel that would be great for a driver or local show type of car with manual windows.
First is an NOS standard panel that was neutral (cream, tan) that I dyed with SEM products and then put on new(ish) deluxe trim.
There is one repair in the vinyl below the striker area and and another at the top right point. There's also a crack around back of the upper right screw. The chrome carpet strip is probably 1/8 of an inch too high. I'd say the vinyl has loss contact with the foam in the lower left as well.
I also replaced the upper felt because the original one was too short and you could see down into the door.
It fits well and with the door shut it's almost impossible to see it as anything but a nice GM panel.
$150 plus shipping.
First is an NOS standard panel that was neutral (cream, tan) that I dyed with SEM products and then put on new(ish) deluxe trim.
There is one repair in the vinyl below the striker area and and another at the top right point. There's also a crack around back of the upper right screw. The chrome carpet strip is probably 1/8 of an inch too high. I'd say the vinyl has loss contact with the foam in the lower left as well.
I also replaced the upper felt because the original one was too short and you could see down into the door.
It fits well and with the door shut it's almost impossible to see it as anything but a nice GM panel.
$150 plus shipping.
Last edited by BarryB72; 05-13-2019 at 08:15 PM.
