WTB: Automatic to 4 speed
#1
Automatic to 4 speed
I'm looking to switch my 1975 C3 to a four speed. If anyone has a junk 4 speed car, or the equipement pulled from a car, or wishes to switch their 4sp to an automatic car... let me know!
#2
Have a bell housing ,clutch fork, 71-74 GM muncie 2 ring 26 spline input, large out put shaft with yoke. And a original 4 spd shifter with linkage out of a C2. maybe some one knows if it works in a C3. You still need a Z bar clutch pedal set up. All depends, how far you are away to pick up. It was working in my 1965, took it out to go with a MY6 overdrive. Located in 57783 SD, we can run 80 mph on some interstate stretches. Ron B
Last edited by itsonlyairandfuel; 02-09-2019 at 09:43 PM.
#3
Highway Man
Hi itsonlyairandfuel,
Is your tranny slip yoke still available?
Does it fit a Spicer 1330 u-joint?
Does it use straps to secure the u-joint?
1.5" Hub O.D. (Sealing Parameter)?
3 5/8" Ground HUB length?
5 11/16" approximate overall length (Center of U-joint to end of spline)?
If all of that is yes, how much do you want for it?
Thanks
Richard
Is your tranny slip yoke still available?
Does it fit a Spicer 1330 u-joint?
Does it use straps to secure the u-joint?
1.5" Hub O.D. (Sealing Parameter)?
3 5/8" Ground HUB length?
5 11/16" approximate overall length (Center of U-joint to end of spline)?
If all of that is yes, how much do you want for it?
Thanks
Richard
#5
Highway Man
Oh darn. i was just looking for the slide yoke for my 700R4 conversion. Sorry to bother you