WTB: C3 Corvette old fender and nose emblems
#1
Instructor
Thread Starter
C3 Corvette old fender and nose emblems
Looking to buy old used fender and nose emblems for my 1970 Corvette. I'm going to use them to locate my new emblem holes. I've looked at diagrams but I'd like to drill holes in the old emblems to locate where the holes go after I locate the emblems. I would need only one Stingray emblem and one nose emblem.
Hope this makes sense.
Thanks
Hope this makes sense.
Thanks
#5
Instructor
Thread Starter
I have a template but I was looking to use the emblems to mark location of the holes while looking at the emblem. It's hard to tell with new emblems and studs on them.
#6
100.00 shipped
these are very hard to find that are not pitted
you can email me grantwong@telus.net
these fit 69 to 72
available to other forum members
#8
Instructor
Thread Starter
I need used pitted ones because I am going to cut off the pins and drill a hole where the pins were to locate the holes on the fenders. I have all new emblems to install but I need to install them in the exact location.
#11
7th Gear
Member Since: Aug 2019
Location: Salisbury NC
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Template for 69 vette fender stingray emblem
I would like to have a template showing the location of the Stingray Emblem on the Fender. I have the AIM but not sure where the start with the measurements.
#12
Drifting
I believe I can trace the hole locations to the top of the louvers with a sinle piece of paper.
Mike