true dual exhaust suggestions
#1
true dual exhaust suggestions
I removed the computer and all smog crap from you 81. Installed Hooker long tube headers. Does anyone know if someone sells a pre bent true dual exhaust for this. I dont care if I have to modify the tranny crossmember. I would rather do that than run both pipes along the passenger side. I would like to get an X pipe in there also. I see that Pypes has one. That is what I'm looking for. But I've heard that the pypes system doesnt fit well.
Dave
Dave
#2
Drifting
I removed the computer and all smog crap from you 81. Installed Hooker long tube headers. Does anyone know if someone sells a pre bent true dual exhaust for this. I dont care if I have to modify the tranny crossmember. I would rather do that than run both pipes along the passenger side. I would like to get an X pipe in there also. I see that Pypes has one. That is what I'm looking for. But I've heard that the pypes system doesnt fit well.
Dave
Dave
#3
I removed the computer and all smog crap from you 81. Installed Hooker long tube headers. Does anyone know if someone sells a pre bent true dual exhaust for this. I dont care if I have to modify the tranny crossmember. I would rather do that than run both pipes along the passenger side. I would like to get an X pipe in there also. I see that Pypes has one. That is what I'm looking for. But I've heard that the pypes system doesnt fit well.
Dave
Dave
#4
Advanced
Member Since: Sep 2006
Location: Hickam AFB Hawaii
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
Go to www.corvettecentral.com. They have a full dual exhaust kit with a crossover pipe and Magnaflow mufflers that fits in the stock location (no crossmember modification needed). It is built to connect to the factory exhaust manifolds, but you can cut the front bends off and weld in reducers to mount to your headers. I put this kit on my 1980 with Flowtech long tube headers. I did the install in my garage with a friend. My friend did the welding for me. It fits pretty decent, although not absolutely perfect.
#5
Drifting
If you want to by the pre bent set up then it will run on the pass side. You will have to mod the cross member to allow the driver side pipe to pass thru, or get your self an earlier style cross member with the two holes and make it fit. I have to modify my driver side crossmember to allow the 3 inch pipe to be even with the pass side.
Custom exhaust shop should be able to do this for you. Crossover and or H pipe. From what I read from the exhaust companies like Borla, Flowmaster, they say either one will give you similar results, but you need to have something vs nothing.
Custom exhaust shop should be able to do this for you. Crossover and or H pipe. From what I read from the exhaust companies like Borla, Flowmaster, they say either one will give you similar results, but you need to have something vs nothing.
#6
Safety Car
I had time and money so I installed a Magnaflow system on my 73.
I sounds good and is not to loud.
Stock manifolds to X-pipe 2 1/4"
From the X-pipe out the back of the mufflers is 2 1/2"
I sounds good and is not to loud.
Stock manifolds to X-pipe 2 1/4"
From the X-pipe out the back of the mufflers is 2 1/2"