How to get the seals off the end of the PS cylinder??
#1
Melting Slicks
Thread Starter
Member Since: Nov 2005
Location: Green Valley Arizona
Posts: 3,185
Likes: 0
Received 106 Likes
on
71 Posts
How to get the seals off the end of the PS cylinder??
Tring to get the end or external seals out of the PS cylinder...but nohting will come out.....
How does one get the seals out of the end of the cylinder? Yes I have the snap ring removed. But nothing else will come out???
Never mind got them out.....
But NOW...the rod scraper looks nothing like the one that came in the kit for Corvette America.
The new parts- one is a copper colored will not slide over the rod...I have to tap it down with a hammer. Then the other piece is like a hard piece of cork or something. It tooks does not slide on, but is easily push down over the rod.
The rod seal is the same though.
Do I have the wrong parts or something???
How does one get the seals out of the end of the cylinder? Yes I have the snap ring removed. But nothing else will come out???
Never mind got them out.....
But NOW...the rod scraper looks nothing like the one that came in the kit for Corvette America.
The new parts- one is a copper colored will not slide over the rod...I have to tap it down with a hammer. Then the other piece is like a hard piece of cork or something. It tooks does not slide on, but is easily push down over the rod.
The rod seal is the same though.
Do I have the wrong parts or something???
Last edited by LannyL81; 06-19-2011 at 06:56 PM.