TimberwolfFXDL

Sure would be nice to bolt them up while the motor's out

7t9l82

only if your a magician.

diehrd

They install easy enough from underneath anyway !

TimberwolfFXDL

I read Hooker's instructions that said lift the car up 2 feet (or something like that). Not sure I have that capability lol

REELAV8R

Sure you do. Use a floor jack and concrete blocks. Jack and block. Repeat, putting blocks under jack, jacking again block tires again, until needed height is reached. Be careful it's a long way up on blocks. Then use jack stands under frame so that you can get under the car and not have to worry about being crushed if the unthinkable happens.

bluedawg

when i changed the engine I used zip ties to hold them out of the way. I already had the headers on the previous engine.

gkull

The driver side fits right up from the bottom. The passenger side i have to install the headers before the starter.

Hooker 1 3/4 Super Comps

resdoggie

Put the front of the car on jackstands at full height. Then use a floor jack with a 6" X 6" block of wood or similar under the front crossmember and jack up to get 2' height.

gcusmano74

Ya need ta eat yer Wheaties first, son.

Mick71