Roller tip rockers for stock ht. valve covers
#1
Advanced
Thread Starter
Roller tip rockers for stock ht. valve covers
Can anyone direct me to a set of roller tip rockers for a Mark IV 454 that will fit under the stock height valve covers? I am running a Crane 242/242 duration 520/520 lift solid cam and want to use the stock covers - these do not have drippers and no power booster depression.
#3
Safety Car
compcam roller tips, pretty easy to put roller tip under stock valve covers.
full roller rockers are more difficult to fit under stock height.
I managed to fit Crane Rollers under stock height with just a bit of massaging on a few the rockers.
full roller rockers are more difficult to fit under stock height.
I managed to fit Crane Rollers under stock height with just a bit of massaging on a few the rockers.
Last edited by 69Vett; 07-28-2016 at 05:11 PM.
#7
Been these type builds for some years now, full-roller platform, retro-hyd lifters/true roller rockers, with 100% stock valve covers and single-thick V/C gaskets.
Many of these builds are on Vette's that get judged at the shows, no problems so far!
Thanks, Gary in N.Y.
P.S. We use mostly Comp's rockers/poly-locks (intakes) with a 1/2 set Crower's poly-locks necessary on exhaust's only.
Many of these builds are on Vette's that get judged at the shows, no problems so far!
Thanks, Gary in N.Y.
P.S. We use mostly Comp's rockers/poly-locks (intakes) with a 1/2 set Crower's poly-locks necessary on exhaust's only.
Last edited by GOSFAST; 07-30-2016 at 08:51 AM. Reason: C
#8
Safety Car
I like those rollers, (lowprofile) and will use them next build,
why poly locks on exhaust only ?
why poly locks on exhaust only ?