Rocker Arms, Valve Springs, Hydraulic Lifters…?
10-15-2016, 12:13 PM
#1
6th Gear
Thread Starter
Member Since: Sep 2015
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Rocker Arms, Valve Springs, Hydraulic Lifters…?
Please recommend me suitable spare parts for my car Corvette C3 1970
L46 engine, small block
motor Heads Bowtie Casting Number : 14011034
Camshaft number: 3965754
Fuell pump from LT1
Side pipes
Holley
Edelbrock Torker II Intake Manifold
I am looking for quality parts that will fit to the engine :-)
Rocker Arms…?
Valve Springs…?
Hydraulic Lifters…?
Thanks Martin
L46 engine, small block
motor Heads Bowtie Casting Number : 14011034
Camshaft number: 3965754
Fuell pump from LT1
Side pipes
Holley
Edelbrock Torker II Intake Manifold
I am looking for quality parts that will fit to the engine :-)
Rocker Arms…?
Valve Springs…?
Hydraulic Lifters…?
Thanks Martin
10-15-2016, 03:55 PM
#2
Team Owner
That is not a good intake, compared to a modern dual plane like a Weiand stealth.
In my early days of H-flat cams i used 1.6 ratio crane roller tips. I had an L-82 and they fit under the cast covers. Much better than stamped, but not a full roller rocker
https://www.summitracing.com/parts/c...7-16/overview/
https://www.summitracing.com/parts/crn-11308-1
In my early days of H-flat cams i used 1.6 ratio crane roller tips. I had an L-82 and they fit under the cast covers. Much better than stamped, but not a full roller rocker
https://www.summitracing.com/parts/c...7-16/overview/
https://www.summitracing.com/parts/crn-11308-1