Cut out on '81,Best place to install.
#1
Racer
Thread Starter
Cut out on '81,Best place to install.
Hi,guys,
in the next future I'm planning to put a set of cut out on my '81(4sp car).I have the hooker headers and stainless steel from Pypes set up with the "X".
Where is the best places to put the cut out?Some one say before the muffler but I think the are too far.
My idea is to install between heather (the end of it)and "X"(the initial part) i think is to reasonable but the cut out outlet in inside of the car(near gearbox9 or outside(near the door?
About the brand I have heard a good think for QTP.Please some one can post some picture of the cut out.
Any advice are welcome.
Sorry for my poor english.
in the next future I'm planning to put a set of cut out on my '81(4sp car).I have the hooker headers and stainless steel from Pypes set up with the "X".
Where is the best places to put the cut out?Some one say before the muffler but I think the are too far.
My idea is to install between heather (the end of it)and "X"(the initial part) i think is to reasonable but the cut out outlet in inside of the car(near gearbox9 or outside(near the door?
About the brand I have heard a good think for QTP.Please some one can post some picture of the cut out.
Any advice are welcome.
Sorry for my poor english.
#2
Team Owner
Member Since: Oct 2004
Location: altered state
Posts: 81,242
Received 3,043 Likes
on
2,602 Posts
St. Jude Donor '05
agree being closer to the header or X. Back by the muffler why bother?
Had to drive mine 5-6 mi to the muffler shop open headers..good gawd that sounded good. at almost 50 youd think one would be "over it" nope
Had to drive mine 5-6 mi to the muffler shop open headers..good gawd that sounded good. at almost 50 youd think one would be "over it" nope
The following users liked this post:
pippo350 (10-27-2017)