Big bore 427
01-14-2018, 04:33 PM
#1
Big bore 427
Anyone built a 3.76 x 4.50 motor? Looking to keep the tork in hand and make
650 h.p. On pump gas. Figure to spin it 7 to 7500. Solid roller with high end valve
control stuff.
650 h.p. On pump gas. Figure to spin it 7 to 7500. Solid roller with high end valve
control stuff.
Last edited by Fia69; 01-14-2018 at 04:37 PM. Reason: Add to post
01-14-2018, 05:54 PM
#2
Le Mans Master
Member Since: Mar 2001
Location: Watkinsville, GA and Glen Cove, NY
Posts: 5,790
Received 855 Likes
on
626 Posts
No but that would be a great combination. Should rev to the moon and maybe kill a little low end. I think all the truck pull engines are big bore short stroke. Give it a shot. Will most definitely like a solid roller rpm range.