Half shaft orientation
09-06-2018, 10:38 PM
Melting Slicks
Thread Starter
Member Since: May 2006
Location: Centerville Louisiana
Posts: 2,364
Half shaft orientation
Does it matter which end goes where? I mixed one up and can’t remember which end had the flange. I’m chasing a vibration on another car and don’t want 2
09-06-2018, 11:27 PM
Melting Slicks
Member Since: Sep 2006
Location: Wichita Kansas
Posts: 2,435
09-08-2018, 03:48 PM
Melting Slicks
Thread Starter
Member Since: May 2006
Location: Centerville Louisiana
Posts: 2,364
I saw a article from Zip that states not to mix the ends up or the sides. Just something else to fret about. Bright side it’s a 50 50 shot
09-08-2018, 07:17 PM
Melting Slicks
Member Since: Sep 2006
Location: Wichita Kansas
Posts: 2,435
The one that you didn't mix up, can you tell the difference end for end on it?
09-08-2018, 09:27 PM
Melting Slicks
Thread Starter
Member Since: May 2006
Location: Centerville Louisiana
Posts: 2,364
09-08-2018, 09:58 PM
Le Mans Master
Member Since: Jan 2006
Location: Butler Pa
Posts: 6,391
Quote:
Originally Posted by
croaker
I saw a article from Zip that states not to mix the ends up or the sides. Just something else to fret about. Bright side it’s a 50 50 shot
Article is wrong. It doesn't matter.
09-09-2018, 11:48 AM
Safety Car
Member Since: Oct 2004
Location: Youngstown Ohio
Posts: 3,807
As stated above, it doesn't matter.
Carbon fiber half shafts installed........mix or match...........
The following users liked this post:
09-09-2018, 06:25 PM
Race Director
Member Since: Apr 2009
Location: Charlotte NC
Posts: 19,294
Quote:
Originally Posted by
bashcraft
Article is wrong. It doesn't matter.
I agree.
DUB