1971 Electrical Gremlins - CorvetteForum - Chevrolet Corvette Forum Discussion

Notices
C3 Tech/Performance V8 Technical Info, Internal Engine, External Engine, Basic Tech and Maintenance for the C3 Corvette

1971 Electrical Gremlins

Reply

 
 
 
Old 09-14-2018, 02:45 PM
  #1  
DHer67
Junior Member
Thread Starter
 
Member Since: Nov 2016
Location: Bala Cynwyd PA
Posts: 20
Thanked 0 Times in 0 Posts
Default 1971 Electrical Gremlins

I have a 1971 350 That will not start. It is has a crate 350 (Mexico block) with Edelbrock heads, intake, and carb, and an MSD ignition (Digital 6AL). One of the POs installed what seems like a home made anti theft system. There is a kill switch hidden in the carpet next to the driver side seat, and a remote flashing LED light in the vent on the top of the dash. When the kill switch is thrown, everything turns off except the LED. There is a separate switch to turn off the LED on the dash also.

I have driven the car for 1 1/2 years... until a few months ago. Drove it on Sunday. It would not start on Monday. Accessories all worked fine. Engine turned over, but no start. After some investigation using MSD's troubleshooting steps, I determined there was no spark. I replaced the coil with a basic NAPA unit per MSD's suggestion to rule out the coil. Still nothing. So I sent the Digital 6AL back to MSD. They "replaced a resistor" and sent it back. Once re-installed I still had the same situation... for a while. The engine turned over, but would not start. I pulled the coil wire to check for spark and still nothing. Frustrated, I put everything back together and just for kicks, tried to start it 1 more time. When I turned the key, nothing happened, then everything went dark. Even the LED will not light.

Any help would be greatly appreciated.

Thanks.

Scott Robinson
AKA DHer67

DHer67 is offline  
Reply With Quote
Old 09-14-2018, 04:59 PM
  #2  
MelWff
CF Senior Member
 
MelWff's Avatar
 
Member Since: May 2006
Location: Danbury CT
Posts: 9,822
Thanked 523 Times in 509 Posts
Default

have you checked the battery with a voltmeter?
what kind of distributor?
can you temporarily wire it to run without the MSD box?
are the original wires that ran to the stock ignition coil positive terminal still there?
if the wires are there, what voltage do you get while cranking and what voltage when the key is in the run position?
MelWff is offline  
Reply With Quote
Old 09-14-2018, 06:05 PM
  #3  
DHer67
Junior Member
Thread Starter
 
Member Since: Nov 2016
Location: Bala Cynwyd PA
Posts: 20
Thanked 0 Times in 0 Posts
Default

The engine was turning over just fine before I took out the MSD box. It turned over great the first few times I tried once I put the repaired box back in. Then it just would not turn over and all the lights went out.

I don't think the battery is the issue. I had it jumpered to my other car to keep it from running down during all this.

It is an MSD distributor. Not sure what model. Have not checked any voltages, but I don't think there will be anything. The entire car is dead.
DHer67 is offline  
Reply With Quote
Old 09-14-2018, 11:25 PM
  #4  
lionelhutz
CF Senior Member
 
lionelhutz's Avatar
 
Member Since: Apr 2007
Location: South Western Ontario
Posts: 9,152
Thanked 341 Times in 316 Posts
Default

Take your voltmeter and,
Check directly at the battery terminals.
Check the cables at the battery.
Check from a chassis ground to the positive battery terminal.
Check from the engine block to the positive battery terminal.
Check from the top big solenoid stud to the engine block.
Check from the horn relay to the engine block.

You have found the area with an issue when you find the voltage missing as you go down that list.

If you find all the above is good, then it's likely the wire running from the horn relay into the cockpit.
lionelhutz is offline  
Reply With Quote
 
 
 


Thread Tools
Search this Thread
Sponsored Ads
Vendor Directory

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.
 
  • Ask a Question
    Get answers from community experts
Question Title:
Description:
Your question will be posted in: