Engine Cradle LS3 & T56 Magnum
Thread Starter
Melting Slicks
Joined: Jun 2011
Posts: 3,114
Likes: 598
Engine Cradle LS3 & T56 Magnum
I am looking for a good quality engine cradle so I can setup my clutch / flywheel / transmission during my LS3 swap.
Everything is out of the car. I would like to test fit everything before installing into the car. I don't want to run the engine outside of the car, just test fit / setup everything.
What is a good product that can support the engine / transmission. I have one similar to this for my ZZ383
Summit Racing SUM-918032 Summit Racing® 2-Piece Engine Stands | Summit Racing
which I don't think will support the transmission as well.
Think something like this. But with wheels so I can move it around. This design doesn't allow the transmission / bell housing to bolt up.
Everything is out of the car. I would like to test fit everything before installing into the car. I don't want to run the engine outside of the car, just test fit / setup everything.
What is a good product that can support the engine / transmission. I have one similar to this for my ZZ383
Summit Racing SUM-918032 Summit Racing® 2-Piece Engine Stands | Summit Racing
which I don't think will support the transmission as well.
Think something like this. But with wheels so I can move it around. This design doesn't allow the transmission / bell housing to bolt up.
Last edited by cagotzmann; Feb 26, 2021 at 11:57 PM.
