optiman

Just purchased new steering wheel. How difficult is it to replace? do I need some kind of puller?

C3 4ME

not hard at all, I've had mine on my 79 off several times. You will probably need a puller, but if all you got was the actual wheel, it will bolt to the hub, and you don't need a puller

VetteHalen

agreed. quite easy, takes less than 10 minutes. it was the first thing i did when i bought my 'Vette - I replaced the worn steering wheel with a clean one. you just need a basic tool or two (screw driver and wrench i believe)...

Shark Racer

No wrench, just a good #2 phillips head screwdriver.

optiman

Great thanks

Mark Riles

The wheel is easy, however it's the horn cap that stumps people. It literally just clips to the hub but over the years a little surface rust can build up making the two very solid together. I generally use a thick rag and a wide flat head screw driver to pop off the stubborn ones. Before re-installation just clean all the teeth of the clip up with a wire wheel or a metal brush and they snap back together perfectly.