FS: 1980 Corvette restomod for cruising and autocross
#22
Is the car still available?
#23
Drifting
Thread Starter
It is still available tonight.
It is still available to tonight but it might not be available tomorrow afternoon. A C3 Forum member is going to test it and drive it home tomorrow morining if he's satisfied with it after a good test drive. And if he doesn't buy it tomorrow, there's another C3 Forum member very serious about buying it too.
I will update this thread if it sells.
Thank you for your interest!
I will update this thread if it sells.
Thank you for your interest!
#25
Drifting
Thread Starter
#26
Racer
Lots of improvements... I think you said 24K worth?....Now a days it would cost a whole lot more than that I would think to do that level of rustomod unless you did all the labor.
#27
Drifting
Thread Starter
The $24K for improvements was for the parts ONLY, and that was for just the major parts, not including hoses, caps, wire, hardware, etc.. The only labor I paid for was to blow the primer, base coat and clear coat. The name of the car club we belong to is "All In My Garage". When I swapped the transmission and replaced the clutch, I used a "Bryan-Eric&Mitch" transmission jack under my lift.
#28
Still say this is probably the best value for an 80 I have seen, if seller is representing car well....Nice stance, nice color,nice wheels and performance to boot.....
Car is way better than a stock 80...Matching numbers? Who cares......After all its not an L-88, 63 split window or a C2 Z06....
Car is way better than a stock 80...Matching numbers? Who cares......After all its not an L-88, 63 split window or a C2 Z06....
The following users liked this post:
MN80Vette (11-09-2018)