Notices
C4 General Discussion General C4 Corvette Discussion not covered in Tech

After market stereo install ? in a 1991 Vette

Thread Tools
 
Search this Thread
 
Old 10-20-2012, 09:58 PM
  #1  
91quasarblue
Instructor
Thread Starter
 
91quasarblue's Avatar
 
Member Since: Apr 2006
Location: east haven ct.
Posts: 117
Received 1 Like on 1 Post

Default After market stereo install ? in a 1991 Vette

Hello have a question about the wires plugged into the Amp under the dash on the pass side. Do I just need the black harness thats plugged into the Amp to bypass the system there are 2 other harnesses but very hard to get them out. I am installing new speakers also, so crutchfield said I would only be using like 4 wires from the GM harness. The black harness seems like the right one.Car harness fits the GM harness. Also does anyone know if those harnesses that are plugged into the Amp get unplugged,Can you get them closer to the area where the tuner was or do you have to run separate wires from GM harness to new tuner harness. Wondering if I could snake that harness back toward old tuner Thanks
Old 10-20-2012, 11:47 PM
  #2  
vetteoz
Safety Car
 
vetteoz's Avatar
 
Member Since: Jan 2004
Posts: 3,556
Likes: 0
Received 10 Likes on 9 Posts

Default

Don't know about wiring but you need to add some resistors to the stock lighting circuit otherwise your SYS light will be on
the CCM monitors the circuit and throws a code if it is disconnected

http://www.corvetteforum.net/c4/dave8476/index4.shtml
Old 10-21-2012, 12:32 AM
  #3  
RandyJ75
Safety Car
 
RandyJ75's Avatar
 
Member Since: Jan 2006
Location: Mt Laurel NJ
Posts: 3,566
Received 4 Likes on 4 Posts
St. Jude Donor '06-'07

Default

Go to the Audio section and read the C4 sticky.
Old 10-21-2012, 04:08 PM
  #4  
RLG
Burning Brakes
 
RLG's Avatar
 
Member Since: Apr 2009
Location: Broken Arrow Oklahoma
Posts: 877
Likes: 0
Received 0 Likes on 0 Posts

Default

If I remember right you will remove all wires from the old radio controller. The resistors wire in behind the radio head in the factory wiring harness. there is a TSB on it.
Old 10-28-2012, 10:18 PM
  #5  
91quasarblue
Instructor
Thread Starter
 
91quasarblue's Avatar
 
Member Since: Apr 2006
Location: east haven ct.
Posts: 117
Received 1 Like on 1 Post

Default

Hello all done with the Aftermarket Radio install not to bad if you did installs in the past obviously the Bose system different animal but not bad especially with a little help from Crutchfield. I installed a JVC CD player with bluetooth HD Radio and Rockford Fosgate Punch 152 51/4" in kick panel and the Punch 165 6.5" speakers in the rear system sounds 100% better than the Old Bose System

Get notified of new replies

To After market stereo install ? in a 1991 Vette




Quick Reply: After market stereo install ? in a 1991 Vette



All times are GMT -4. The time now is 02:51 AM.