What did you do to your C4 today?
#3501
Drifting
Another day, another video....
The following users liked this post:
C5 4me (03-12-2018)
#3502
Instructor
Replaced the drivers side O2 sensor. (Was telling the computer that it was lean when it wasn't. It was adding so much fuel, the car had no power, and I could have given diesels a run for their money in a "coal rolling competition" LMAO!! Also changed the oil and the ZF6 trans fluid, as well as replacing the transmission drain plug since one of the previous owners mashed the hell out of it. They must have hit something hard!
Connor Coughlin
Connor Coughlin
#3503
Drifting
dug into my headlight gear..the GEAR is fine (as expected), its the 3 plastic pellets that are (were...since they are dust now) the problem.
That large pile of dust is whats left of the 3 shiny new pellets you see next to the gear. the gear itself is good as new (26 years old) so if your lights just make noise when activating them BUT they function, then its just the pellets but if your lights don't activate (move) are do but aren't in sync...THEN you should buy new gears as well.
That large pile of dust is whats left of the 3 shiny new pellets you see next to the gear. the gear itself is good as new (26 years old) so if your lights just make noise when activating them BUT they function, then its just the pellets but if your lights don't activate (move) are do but aren't in sync...THEN you should buy new gears as well.
Last edited by mark970; 03-12-2018 at 01:04 PM.
#3504
Racer
It seems a lot of guys do that down here since replacing the core is a PITA.
#3505
Melting Slicks
Just had a new top put on my 95. All new weatherstripping. I opted for made in the USA. The guy who installed the top sais there is a difference and it was worth it.
#3506
Melting Slicks
#3507
Instructor
Got to redo the valve cover gasket job I did 4k miles ago because I decided to be a cheap A$$ and skimp on the gaskets the first time I did it. This time through I opted in getting the thick, premium one since the previous gasket leaked like there was no gasket there. (Like everyone says, and myself, you get what you pay for.... I tried my luck and failed lmao)
Connor Coughlin
Connor Coughlin
#3508
Le Mans Master
I tried to drive it, but the starter just clicked. I charged the battery and it wouldn't hold a charge.
The good news is that the battery was still under free replacement warranty. I picked up the new one this morning and now good to go for no cost.
The good news is that the battery was still under free replacement warranty. I picked up the new one this morning and now good to go for no cost.
#3509
Racer
Mom is back from winter hibernation, so the Vette had to come home.
Fired right up & ran great !
Need to check the odometer, getting real close to 23, 000 miles
Fired right up & ran great !
Need to check the odometer, getting real close to 23, 000 miles
#3511
Safety Car
Designed and installed a new feature into the remote keyless entry system in my '84. I can now close the windows within 30 sec. of turning off my ignition key . . . just like a "modern" car! No need to turn on the ignition to close my windows!
The following users liked this post:
kael (03-16-2018)
#3513
Burning Brakes
Attacked shifter **** rattle. Put in aftermarket liner for acrylic top. (As others have said, I had to trim the tabs.) Ordered emissions system parts. Let's see, only 20 or a hundred more things on my C4 to do list.
#3517
Race Director
Member Since: Feb 2002
Location: Compound in the Grove, Ga.
Posts: 11,328
Received 910 Likes
on
583 Posts
2020 C3 of the Year Finalist - Unmodified
2019 C4 of Year Finalist (performance mods)
2018 C4 of Year Finalist
2015 C4 of the Year Finalist
St. Jude Donor '16
2020 C3 of the Year Finalist - Unmodified
After 193k miles changed all the hoses on the 95 LT1 daily driver, They were getting a bit soft
Last edited by FASTAZU; 03-15-2018 at 10:20 PM.
#3519
Instructor
Stack of parts ready to go on
Yesterday my front porch must have looked like a shared terminal for UPS, FedEx and USPS..sorry DHL. My new KYB front and rear shocks, prothane bushing kit, connector for the passenger front marker light, front and rear main seals, oil pan and gasket, smog pump delete kit and lots of other gaskets, relays and lots of other little bits ..etc arrived. She is ready to be "unbubbafied" for spring.
I'm still working on the wife to get the hood fixed. The PO must have either had a cable break or they left something on top of the passenger side engine compartment because the hood is cracked on top and bottom (bottom side is cracked through the box support). They did a shitty fix by plastering fiberglass on the underside and then spraying it black. I'm having trouble finding anyone who is willing to tackle it here in my area, at least at a fair price. One guy wanted $6K to do the work. For $500-$800 I could buy a used hood and have it sprayed for another $1,500 - $2,000. For $6K I would think I could get the hood fixed and a decent repaint of the entire car.
I might just tackle it myself and have a good paint shop blend the paint in.
I'm still working on the wife to get the hood fixed. The PO must have either had a cable break or they left something on top of the passenger side engine compartment because the hood is cracked on top and bottom (bottom side is cracked through the box support). They did a shitty fix by plastering fiberglass on the underside and then spraying it black. I'm having trouble finding anyone who is willing to tackle it here in my area, at least at a fair price. One guy wanted $6K to do the work. For $500-$800 I could buy a used hood and have it sprayed for another $1,500 - $2,000. For $6K I would think I could get the hood fixed and a decent repaint of the entire car.
I might just tackle it myself and have a good paint shop blend the paint in.
#3520
Melting Slicks
I got rid of the Sawblades which were a little banged up from the previous owner. I bought some ZR1 Replica Wheels 9s in the front and 11s in the back. I went with chrome instead of silver because the 11s were not available in Silver at the moment. I have next to no patience. I do need to buy some center caps.
get some pics today
get some pics today